06-07-2021 11:57 AM
Hi,
We have a setup with a pair of fabric interconnects and few UCS 5108 chassis
Can I add UCSX 9508 chassis to the same set of fabric interconnect? (after changing it to intersight manage mode)
Solved! Go to Solution.
06-07-2021 03:50 PM
Yes you can do this. The hardware that you have installed in the 5108 will need to be supported by IMM mode as well and on the proper firmware version.
06-07-2021 12:33 PM - edited 06-13-2021 09:14 AM
Might be helpful if you have basic drawing of what you are proposing to make sure we are understanding your question fully.
Kirk...
06-07-2021 01:53 PM
Yes, you can connect the 9508 to 6400 when you use IMM, but will have to setup everything in Intersight in order to bring the links up to the IFM module and everything will need to be managed via Intersight. You cannot manage the 9508 in Intersight and then manage 5108 via traditional UCSM.
06-07-2021 02:45 PM
Thanks for info. The more specific question is
Can I manage 5108 from the same set of FIs that manage 9508 chassis in Intersight Managed Mode
i.e. FIs running in IMM and has both 9508 chassis and 5108 chassis attached to it
06-07-2021 03:50 PM
Yes you can do this. The hardware that you have installed in the 5108 will need to be supported by IMM mode as well and on the proper firmware version.
06-07-2021 03:57 PM
Awesome, is there any document that describes the scenario. Would like to share with the team.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide