04-12-2013 08:58 AM - edited 03-01-2019 10:58 AM
I'm having issues with the NTP setting on the C22s we purchased. I can configure NTP just fine through the CIMC but it defaults to UTC and I need to set the offset to -8 for PST so that the system Clock is accurate.
The documentation I've been able to find says to ssh into the CIMC type scope system then scope service then set the offset but the scope system command doesn't work. Neither does the GUI instructions that I've found which say that the offset is in the Admin tab of the CIMC.
Anyone have any insight as to how I can set the NTP offset? For now I've disabled NTP as having it off by 8 hours will play havoc with my VM's on boot.
Thanks!
04-12-2013 10:34 AM
Hello,
What happens if you change the time in BIOS to match your local time and then enable NTP ?
Does it stays synced with NTP source ?
Padma
07-22-2013 02:03 AM
Hello,
I'm running into the same issue (UCS C-220M3, Cisco Business Edition 6000). After my research I am afraid NTP Offset is not supported at all when the server is managed directly via CIMC (rather than UCS Manager).
The Menus/Commands the OP mentioned are from UCS Manager.
Cheers
David
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide