Unified Computing System Discussions

Hi team from the community,  I want to install the Cisco Security Manager 4.2 over Vmware 5.0, I Looked in the installation guide but  It only supports VMWARE 4.1.RegardsJose

Hi all,I've got several service profiles that show a warning fault in UCSM (2.1(1e)) that I can't explain.  The service profile is highlighted in blue in the tree view under the Servers tab in UCSM:And, the general table for the service profile shows...

I did a manual upgrade from 2.0.4b to 2.1.2aInfrastructure went okThen I created a Host Firmware Package, added it to the SP: Adaptor, BIOS, Controller was updated properly, NOT CIMC.Finally I found that customer had a management firmware package, de...

HI, I have two FI 6140xp, 11 chassis, and i´m planning to upgrade its UCSM and firmware, from 1.4(L) through  2.0(5) but i need to know if this is the last stable version (2.0(5)),  or if exists another upper stable version.Thanks,

Anyone wanting to see the functionality of the new UCS 2.1 code without actually upgrading your systems - try out the UCS Emulator, now upgraded to version 2.1!http://developer.cisco.com/web/unifiedcomputing/ucsemulatordownloadI use this tool all of ...

                   I have setup a vlan in Dual Mode, but traffic will only pass though 1 of the fabric interconnects. If I setup a VNIC to use vlan x and change the nic to use only fabric B, traffic will pass. Change the nic to use only fabric A and ...

I understand that the port side of the 6248UP is considered the back. I was wondering if it is possible to get back-to-front airflow with the 6248UP. Essentially making the port side the front

Hi,I'm designing a Cisco UCS Blade server enviroment and want to use Cisco VM-FEX. I also have Cisco Nexus 5548UP and Nexus 7009 & 7004 datacenter switches. I need advice on the following:What is the Parent switch for Cisco VM-FEX? Is it:Cisco 6200 F...

I have 4 x 2.1(2a) UCS Domains connected to aUCS Central 1.1a server. Everything is showing up correctly EXECPT for the Servers tab. It is only showing templates in  the "Local Service Profile Templates" section. There are no "Local Service Profiles"...

Using DCNM-SAN with UCS (2.1.2a); I created on all FC devices (MDS and N5k) a user "dcnmuser" with netadmin rights. I also created a snmp v3 user "dcnmuser" with UCSM. Then I did a fabric discovery with DCNM-SAN; I see the fabric, MDS, N5k and FI, ho...

We are purchasing Cisco USC B200's and Cisco USC B440's.  I need to attach a remote image (.iso) file via commandline (for full automation of the OS Build).  I cannot seem to figure out how to do this without using the gui tool.Does anyone know how t...

Do you have any information about the licensing for the ports for N5596?

dear experts;I meet a problem.I creat two vhbas in my B200M3 server .one of my vhbas cannot fcping in the SAN switch(the other vhba is normal )，however SAN switch can see it(show npv status in FI is normal,VIF path is up)，just cannot fcping,and we ca...