- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-30-2017 09:12 AM - edited 03-01-2019 01:20 PM
Hello Experts,
We have Cisco UCS C220 (SNS-3515 bundled), we want to boot some ISO from vKVM but unfortunately in boot order, only pre-installed OS i.e Cisco ISE and network interfaces are showing. We cannot see vKVM DVD option there when goto Boot menu from BIOS.
We can set the boot option with vKVM DVD from CIMC itself but that boot order configured under CIMC is unfortunately not working. Our CIMC version is 2.0(h)
We want to know whether an upgrade is required or should i need to enable some option in the BIOS settings in CIMC ?
Regards,
Muhammad Awais Khan
Solved! Go to Solution.
- Labels:
-
Other Unified Computing System
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-08-2018 11:19 AM
Could you solve this problem?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-30-2017 09:16 AM
Since this is a security appliance, there are a lot of options that are locked down. You typically require a special ISO file that is secure and can boot on the appliance. If you go to BIOS options, you should see "secure boot" checked and unable to toggle.
For any other questions on what you can and cannot do, I would open a TAC case for assistance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-30-2017 09:29 AM
Thanks for the feedback. We have couple of other SNS-3595-K9 appliances but we did not see this problem with those.
The 1st problem is that atleast we should see the vKVM DVD in boot order, we want to boot the same ISO which is currently installed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-08-2018 11:19 AM
Could you solve this problem?