cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
562
Views
0
Helpful
4
Replies

UCS C220 Virtual Drive configuration Error

Sami Ahmad
Level 1
Level 1

Hi,

I have been encountering an issue while creating a virtual drive out of two HDDs and configuring RAID on them.

I hope, i can continue to create VD over CLI than GUI with no errors. But, is this something i need to worry about?

I couldn't find much in the troubleshooting guide on the error as well. Attached screenshot of error.

UCS C220

RAID Controller: LSI MegaRAID SAS 9266-8i

Firmware: 23.28.0-0010

Thanks,

Sami

1 Accepted Solution

Accepted Solutions

Keny Perez
Level 8
Level 8

Hi,

Try to configure the VD from WebBIOS (reboot the server and press Ctrl+H when prompted during POST).

I dont have all the details bt you MIGHT be hitting this bug or a variant : 

https://tools.cisco.com/bugsearch/bug/CSCuf80285/?reffering_site=dumpcr

 

 

HTH,

-Kenny

View solution in original post

4 Replies 4

Keny Perez
Level 8
Level 8

Hi,

Try to configure the VD from WebBIOS (reboot the server and press Ctrl+H when prompted during POST).

I dont have all the details bt you MIGHT be hitting this bug or a variant : 

https://tools.cisco.com/bugsearch/bug/CSCuf80285/?reffering_site=dumpcr

 

 

HTH,

-Kenny

Thanks Keny.

Yes, I will probably approach it via CLI. I am just wondering, as the server already on 2.0.1(b) and the bug was reportedly fixed on 1.5(2).

I will let you, if it works on the CLI

 

Thanks again.

Thanks Kenny, webBIOS worked for configuring new VD.

 

Sami

My pleasure!

 

-Kenny

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: