cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3158
Views
0
Helpful
1
Replies

UCS-C220M3- PXE-E61: Media test failure, check cable

MUHAMMED SHAFI
Level 1
Level 1

Dear All,

I have UCS-C220M3 server i am planning to install VWLC(Vertual Wireless lan controller ) and Cisco Prime i coonected power ,put the hard disk after i start UCS but it showing  PXE-E61: Media test failure, check cable  this error 

this my 1st UCS work anybody can help me how to configure UCS-C220M3 rack mount server i have two vmVMware vSphere licence

how to i can install and configure  WLC and Cisco prime in UCS-C220M3 server

Could you please help me...

I am waiting for your valuable replay

Regards

Muhammed

1 Reply 1

padramas
Cisco Employee
Cisco Employee

Hello Muhammed,

""  PXE-E61: Media test failure, check cable  "'

Above message says you have enabled LAN / PXE boot in boot order but have not connected physical cable to LOM NIC ports.

To achieve your goal of deploying vWLC and Prime VMs, you first need to start with configuring CIMC.

Once you can reach CIMC over the network, you can use KVM and install the ESXi.

After installing ESxi, you need to follow the installation docs of vWLC and Prime.

Padma

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card