Unified Computing System Discussions

Hello,I am at a bit of a quandry. I have been trying to find somewhere, anywhere, that indicates that the following configuration is supported/certified by the companies involved.Cisco UCS B-Series serversWindows 2012EMC VNX 5500 BlockFiber ChannelHe...

Dear Team,Kindly share how to configure connectivity between Fabric Interconnect and MDSwhat are the steps to be followed in establishing a successful connection between FI and MDSWe have a tape library from IBM and trying to connect the same to FI v...

I've just lodged a service request for this, but as I don't have a service contract I'm not sure how much support I will get from Cisco vs them just replacing the whole unit..In any case, It's a LFF C240 M3, dual CPU. It was purchased with an LSI2008...

Hi All,I have one UCS server in my lab, which has multiple VMs configured with IP range of 192.168.0.0/24 and each IP is pingable from each other. Now All those VMs have some testing application installed on it which need multiple IPs. All those IPs ...

                   Can anyone tell me if Cisco hosts a repository for VMWare Update Manager to download Cisco Gold Standard certified updates from?Basically what I am trying to find out is this.If I let Update Manager download updates from VMWare dir...

Hi all!I have a doubt, is possible to aggregate links, with LACP or similar, between Fabrics interconnet UCS 6200?I have two buildings (they are very near, a couple of walls in the middle) and I would like to install a UCS Blade server chassis in eac...

Hi everyone,I was trying to perform an update in SCU, but there is no update icon.Have you seen this behaviour?My version is 3.1(3):Kind regardsMaciej Wilk

Hiwe have UCS C220M3 server, which have 3 NIC ports, one for Management  and two for Data. I need to configure 1 IP address for Management port (for CIMC), other two ports will be used for normal data transfer. when i give the IP for CIMC and connect...

Hi,Is there a pre-production tests plan from cisco to validate that a new UCS setup is A-OK?I found some stuff on google. But nothing from cisco.Thanks for any help.Stephane.                  

Hi Guys,I want to know whether UCS support jumbo frames when booting from SAN. Presently I am trying to boot my Blades from iSCSI with jumbo frame enabled.the storage is netapp sitting on two seprate vlans.Any help will greatly appreciated.Thanks

Hello folks,I have had a real live setup where there was a coling problem.all cooling went down and the user did not spend mony on survaling the tempeture.The UCS chassis shut down automaticly when it was to hot and booted it self when there was cold...

I have configured multiple UCSM with UCS Central. I want credential of each UCSM through UCS Central.Please let me know, how to do thatRegards,Shashi