UCS FI-IO Module stuck in discovery

[frednetech]

An installation of the ucs 5108 mini is stuck in discovery and unable to see the blade servers in slots 1 and 2. Efforts to download chassis logs is not succeeding either.

Below are some of the errors being reported.

 [FSM:FAILED]: configuration of IOM 1/1(left) connectivity to fabric interconnect A(FSM:sam:dme:EquipmentIOCardBaseFeConn). Remote-Invocation-Error: no connection to MC endpoint.

[FSM:FAILED]: configuration of IOM 1/2(right) connectivity to fabric interconnect B(FSM:sam:dme:EquipmentIOCardBaseFeConn). Remote-Invocation-Error: no connection to MC endpoint.

System came shipped with ucsm 3.2 (2e), have upgrade it to 4.0 (1a) and later downgraded to 3.1 (1j) (the version on a working setup) with the same errors persisting.

Opened a support case but not much help could be rendered.

Any help please.

Attached are some screenshots of error.

[frednetech]

Any help out there?

[Niko Nikas]

Hello,

From looking at the screenshots and the errors you listed in the post, I would suspect some kind of software issue.

What do you see when you run the below commands from a SSH session to the environment?

[username]

[password]

connect local a

show cluster ext

show pmon state

exit

connect local b

show cluster ext

show pmon state

--

Niko

[frednetech]

Thank you for the feedback. See the output of the commands, attached and advise.

[Niko Nikas]

Frednetech,

Looking this over, it looks like the processes are running (although we may want to see what the logging for some of those is reporting). Do you have a case open for this issue?

--

Niko