ā02-17-2011 02:01 PM - edited ā03-01-2019 09:50 AM
Are there any known issues with a Q-Logic adapter after upgrading to 1.3(1p)?
I just upgraded UCS firmware to 1.3(1p) from 1.3(1c) and I cannot create 2 vHBAs. I get the config-failure and error is clear, not enough vHBA's
When I delete one vHBA profile associates fine.
Anybody seen this?
ā02-17-2011 04:44 PM
I could not find anything related to this problem after upgrading to 1.3(1p).
Are you showing any faults on the blade itself?
Are any ports down on the Fabric Interconnect, IOM or backplane on either side?
ā02-17-2011 05:20 PM
Are you showing any faults on the blade itself?
No fault on the blade, other than a config-error being reported as the overall status of the service profile
ć
Are any ports down on the Fabric Interconnect, IOM or backplane on either side?
No ports are down on the I/O module nor the backplane. FIC ports are all fine. I will try another acknowledge of the Chassis and see what happens
ā02-17-2011 06:32 PM
Is this a newly created SP or was working before?
If new, what is the Fabric ID set to on the vHBA's?
For Qlogic cards, they cannot both be on the same fabric i.e one needs to be A and the other B.
Thanks
--Manish
ā02-17-2011 07:51 PM
Manish,
This was newly created SP and yes one HBA is pointing to FIC A and other to FIC B
ā02-18-2011 07:58 AM
Just as an update to everybody who looked at this thread:
Re-seating the Fabric Extender (IOM 2) helped and it fixed the problem. Now I can create 2 vHBA's one on each path.
May be I did miss something in the steps while upgrading or did something out of sequence, not sure.
Good news is that it works now
Thanks for all your comments
-Sukesh
ā02-18-2011 09:28 AM
Sukesh,
Having seen this before on the field, I would bet when you reseated that IOM, the running firmware, 1.3.1p for pushed to the device and this could have resolved the issue. I am confident that you performed the upgrade steps correct, I just feel the firmware did not upgrade that IOM.
Sent from Cisco Technical Support iPhone App
ā02-18-2011 11:24 AM
Thanks for letting me know that you have seen this in the field.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide