Solved: UCSM IP Pool Config ?

Scott.Lau · ‎01-10-2018

I have an IP Pool ext-mgmt with a block of 100 IP's. Only 96 are being used and I want to edit the block to remove these extra 4 to utilize them in another cluster. Is this possible?

Can multiple blocks be added to a IP pool with the same subnet, just different IP range?

Thanks!

Wes Austin · ‎01-10-2018

You can add multiple blocks to an IP pool. For your situation, you will need to remove the block completely and re-create a new one with only 96 addresses. There is no way to remove IP from a block. The servers may or may not be assigned the same IP addresses after you re-apply the block, but really as long as they have an IP address, you can manage them via KVM, etc.

View solution in original post

Wes Austin · ‎01-10-2018

You can add multiple blocks to an IP pool. For your situation, you will need to remove the block completely and re-create a new one with only 96 addresses. There is no way to remove IP from a block. The servers may or may not be assigned the same IP addresses after you re-apply the block, but really as long as they have an IP address, you can manage them via KVM, etc.