FI-A L1 -> FI-B L1 using cat5/6 (as short or as long as you want. We used a half foot cable)
FI-A L2 -> FI-B L2 using cat5/6 (as short or as long as you want. We used a half foot cable)
FI-A and FI-B management is cat5/6 to a management network switch. Use however long of a cable you will need.
FI to core, depends on your situation. You can get TwinAx that is 10m (30ft) if that's long enough to connect to your core, and your core supports the TwinAx SR. However in my case it isn't long enough. Our UCS came with two 10Gbps Optical SRs. We are using two uplinks from each FI and one goes to 5k-1 and the other to 5k-2.
General summary would be: short run of 10Gbps between cisco devices, use TwinAx. Longer run, use optical SR with fiber cable between the devices. All management/cluster cables are standard cat5/6 Ethernet cables.
Mega raid option does not appear when the server comes to the bios screen, I see the Megar aid PCI card when I look at the bios but I can not do in the configuration because all setting is disable. There are three from this server and they all have t...
•This field guide is meant to be used by customers for cleaning up an existing HyperFlex Edge deployment for the purposes of reinstalling.
•The procedures in this guide are DESTRUCTIVE. Make sure all VMs and data are backed up before proceedi...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...