cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
538
Views
0
Helpful
2
Replies
Highlighted
Beginner

Upgrading from 2.0 - 2.1, Default Zoning disabled

While planning for an upgrade from 2.0 -> 2.1 we noticed the warning about Default Zoning not being supported in 2.1(1a) and later releases. Is it possible to reconfigure and disable Default Zoning without causing any disruptions?

The system is running on a 6120XP with an 8GB FC expansion module and four connected Storage FC Interfaces. One configured VSAN with Default Zoning enabled.

Everyone's tags (5)
2 REPLIES 2
Beginner

Upgrading from 2.0 - 2.1, Default Zoning disabled

Are there any official guidelines from Cisco released regarding the removal of Default Zoning Support? Any advice is welcome!

Collaborator

Re: Upgrading from 2.0 - 2.1, Default Zoning disabled

Andreas,

In UCSM 2.1 Default Zonning is disabled an cant be used anymore, you need to create the VSAN again and define it manually.

See this thread for more information:

https://supportforums.cisco.com/thread/2185462

Please rate ALL helpful answers.

-Kenny

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards