Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
862
Views
0
Helpful
2
Replies

Upgrading from 2.0 - 2.1, Default Zoning disabled

Andreas Linde
Level 1
Level 1

‎12-04-2013 07:22 AM - edited ‎03-01-2019 11:23 AM

While planning for an upgrade from 2.0 -> 2.1 we noticed the warning about Default Zoning not being supported in 2.1(1a) and later releases. Is it possible to reconfigure and disable Default Zoning without causing any disruptions?

The system is running on a 6120XP with an 8GB FC expansion module and four connected Storage FC Interfaces. One configured VSAN with Default Zoning enabled.

0 Helpful
2 Replies 2

Andreas Linde
Level 1
Level 1

‎12-12-2013 08:37 AM

Are there any official guidelines from Cisco released regarding the removal of Default Zoning Support? Any advice is welcome!

0 Helpful

Keny Perez
Level 8
Level 8
In response to Andreas Linde

‎12-13-2013 07:16 AM

Andreas,

In UCSM 2.1 Default Zonning is disabled an cant be used anymore, you need to create the VSAN again and define it manually.

See this thread for more information:

https://supportforums.cisco.com/thread/2185462

Please rate ALL helpful answers.

-Kenny

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking products for a $25 gift card