Buy or Renew
Buy or Renew
ghyacin
Level 1
Level 1
Member since ‎01-05-2017
‎06-07-2023
Recent Badges
Awards

User Statistics

  • 27 Posts
  • 0 Solutions
  • 10 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
See all
20 Replies
10 Replies
5 Replies

User Activity

Routing between 2851 Router and nme-xd-48es-2s-p etherswitch

02-13-2019
I have a 2581 router with an etherswitch installed, configured and routing back and forth but this is done with a physical patch cable connected from gi 0/1 (R) to gi 1/0/1 (S).  I would like to have the connection made using the internal gi connecti...

POE issue with NME-XD-48ES-2S-P in 2851 ISR

03-16-2018
Hey, I have a 2851 router with a NME-XD-48ES-2S-P installed.  I have read that it's best to have the port that communicates with the router set to "no switch" with an IP address, but my setup only works with the port in "switchport trunk mode" to pas...

CCP Express 3.3 and 2921 ISR

04-04-2017
I have downloaded CCP Express from CISCO, copied it to the router, extracted the file to the flash, configured the router as shown below but I am not able to get the CCP Express page to load. I am able to login when I try connecting to the routers IP...

How to Inter-connect vlans on cisco router with etherswitch installed (NM-16ESW)?

01-06-2017
Hey, I'm pretty new to Cisco commercial equipment's but I'll get straight to the point. I have a Cisco 2650 with a NM-16ESW module installed, I have vlan 10, 30, 80, 99, and 150 setup.  I have a DHCP server handling IP addresses for all the vlans acc...
Community Statistics
Member Since ‎01-05-2017 12:24 PM
Date Last Visited ‎06-07-2023 12:03 AM
Posts 27
Helpful Votes Given To