Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Why does this say Fixed? I just tried both trains...
I tried the latest in the 17.15 Train: ess3x00-universalk9.17.15.02.SPA.bin (Which still has the bug in it)I tried the latest in the 17.16 Train: ess3x00-universalk9.17.16.01.SPA.bin (Which stil...
Is it possible to use Hostnames instead of IP addressing for ISAKMP when a Spoke VPN comes into the Hub using routers?The issue is the remotes could come from anywhere, so the Hub will never know the IP address to set up different Pre-Shared-Keys in ...
I have a customer who has the same subnet in 2 different locations. They need broadcast and multicast to go to each other. Neither site has duplicate address to the other. previously connected by switches. Noe need to connect them by routers over a r...
Is there a way to set the Codec when a call is placed using CCME and the phone is located across a wan? Since the Phones are registering to the Hub I am guessing the hub thinks it's a local phone and sets all calls to G.711. Would like the ability to...
I have a setup where I have a default route to the internet for a VPN router. It connects to a base station VPN END Point through the Internet. I use ROUTE-MAPS to send packets from the LAN interface to the VPN with no problem. The situation I have n...
Using 12.4, I got it to work. The only issue I had was that the Static Nat addresses of the Spokes needs to be the address of the Interface on the outside public network. IE. "ip nat inside source static fa0/0" if FA0/0 is the outside address. let me...
Will I have to use DCE cables from the router to the muxes and config the Bandwidth and such on the router interface to provide the needed timing and clock or will this act as a transparent tunnel between the 2 serial ports.Thank you again, Rick
