Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Do any of the Jabber clients have the ability to display the full external number, like is shown on the display of an IP phone? Or is it still not possible? We use 5 digit DNs with a variety of different prefix's, so it would be very useful for us...
Hi All,
Just throwing this question out to the community as TAC have been less than helpful in resolving our issue, have a case open for 2 months now with no progress.
We have an issue where BFCP presentation does not always work between our Cisc...
Hi All,
Looking for a comparison between these two models of switches, in particular the SG550XG-24T vs SG350XG-24T. I would be planning on using these in a collapsed core design, running MSTP, and would like some form of first-hop redundancy. I can ...
Hi,I would like to setup certificate based VPN authentication on a Cisco router but with the auth done by a RADIUS server. I have not been able to find an example of this. I have looked at documentation on Radius with username/password and documentat...
Real easy one here... In the attached diagram, what would be the best way to load balance between the two sites? Note the HP TOR switches don't need to be linked. I'm thinking PVST+. There are only 3 VLANs. Is there anyway to load balance the default...
Did you get a resolution? I was about to purchase another set of certs but I have a TAC engineer saying that Tomcat-ECDSA is not supported in 11.6. We're on 11.6(1).
Appears to be resolved. After this case was finally escalated, another engineer suggested to try changing the 'Media encryption mode' setting on the CUCM neighbor zone from 'Auto' to 'Force unencrypted'. I am now just waiting for an explanation as to...
