Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a C2901 and 2 HWIC-16A for terminal server purpose. Today I am trying to integrate 2 brand new catalyst c9300 I Don't find why I Don't succeed to I add regularly new equipment and with c9300 I have “connection refused”, but I use a c...
Hello,
I have a FW between two privates networks and it block multiples unknown IP addresses (they don't belong to my two privates networks)
I'm would like to find a way to locate them.
I checked every ARP table but I didn't find them in it. (I t...
Hello I have an architecture like this :
Two L3 switchs (C6506) and access switches (C3750x) are connected on my C6506. My access Switch(AS) works by two and generally manage only one VLAN (one VLAN by specific application).
On my access switch th...
Hello, I really need help I don't find a way to configure a router by file trough a terminal access server (C2901 + HWIC-16A). I need this for check syntaxe and validate configuration on my lab before deploying it on my exploitation network. I use p...
Hello, I try to configure a C2901 with two Hwic-16A. when I try to send a configuration on a client, the server send to quickly commands and the client don't manage the flow. there is a lot of errors because commands line are merged ! (there is a lo...
hello,same issue, client complain about performance. from what I understand, "comestic" is there is verbose logs, but no system failure, but CSCvz58423 talk about performance issue ...
Hello, Thanks for your reply It is forced to 9600 but I believe, because it is the default value it is not displayed in standard “sh run” but in “show line” value is set at 9600 I think understand why I have “connection refused”, at the first connec...
