Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We are deploying FPR 2110 - FTD in an HA mode. FMC is to be installed for the deployment and further management of FPR2110 units. We are in a situation where we might have to install FMC on a remote location which is connected via 20Mbps Layer...
Hi All ,
I am having an issue with the connectivity between My Nexus 9000 and My old switches ( Cisco 2960,3560 ) .
Scenario is as follows .
1- I have two nexus switches with vPC configured between them and then connected to an ASA-5545x Cluster
2...
Hi Cisco Community ,
Need to know whether in Cisco vPC are the interfaces shown as if in a single chassis when logged in to Mgmt IP ?
I have configured two Nexus 93108 chassis with vPC between them and vPC is successful , but unlike Cisco Stack I ha...
Hi Jessica,What I was able to observe after assessing the extract you pasted is the following.Before I proceed, I would like to ask you a question that is there a specific reason that makes you config VTI and Crypto Map together? Is it a requirement ...
Hi baselzind,FCoE is Fiber Channel over ethernet, this is used when you want to traverse the combination of LAN and SAN traffic over your layer 2 connectivity. If you select mismatched SFPs in this case you would not be able to traverse the SAN traff...
Thanks for the update Aman, before we go in to details, I would request you if you could share the below outputs from FI and Core switches connecting each other over trunk.1- Trunk port allowed vlans2- Trunk port forwarded vlansPlease mark all the he...
Hi Manu,
The main difference between the two Cisco SFPs is that SFP-10G-LR supports FCoE, whereas SFP-10G-LR-S does not support FCoE.This is why the variant 10G-LR and 10G-LR-S have a slight difference in prices.Which means that if you have an interc...
Hi ,let me help you out here with a simple check to run for future as well in order to avoid any confusion.Part-1 SFPs1- SFPs on both the sides are recommended to be of same type, not necessarily of same OEMfor example if switch has an SFP-10G-SR, th...
