Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hola, espero me puedan ayudar con un problema con mi @FTD1010.Estaba configurando mi equipo FTD1010, al momento de la configuración me salió este mensaje " Manage the device locally?—Enter yes to use the FDM or the CDO. A no answer means you intend t...
Hello everyone, can someone please advise me to solve this problem;I have 3 Cisco @Firepower 1010 Threat Defense Softwaresoftware 6.6.1-xxI want to configure @site-to-site VPN. I have done all the configuration that the wizard guides me but the conne...
Hello, can someone help me with information please?
I have 4 Cisco AP equipment, AIR-CAP2602I-A-K9, none of them I can use since I don't have a controller, but it strikes me that I can't even connect by console cable I have used putty,
teraterm, moba...
Hola, alguien me puede colaborar con información por favor.?Dispongo de 4 equipos AP Cisco, AIR-CAP2602I-A-K9 ninguno de ellos los puedo utilizar ya que no tengo una controladora, pero me llama la atención que ni siquiera puedo conectar por cable de ...
Hola Sergey, gracias por tu valiosa aclaración.Es correcto, está trabajando como FDM y tú respuesta lo confirma. El problema fue que no coloque la "management interface"con los datos del Gateway y en su lugar se encontraba como DHCP. Gracias
Hi Rob, sorry for the delay.I have tried the ping to the other network from the FPR and from an internal computer and the ping does not respond. The VPN connection is active, I have used the command that you advised me to check and everything is ok T...
Hello Rob.Thanks for supporting,Is there a command to generate traffic to the remote network.?The problem is that the ping is not reached from the local network 192.168.200.0/24 to the remote network 192.168.50.0/24, even in reverse. In this case pin...
