Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
Our audit team has observed following vulnerabilities in Cisco ASA (5520) firewall. Please suggest how to fix it.
1) Internet Key Exchange (IKE) Aggressive mode is enable and they asked us to disable the same.
Please let me know what will ...
Dear Team,
We need to enable "Host Scan" feature on our ASA(5555). As per my understanding, we need to have AnyConnect premium license to enable this feature. I have few doubts on this. Please help me to clarify below points :-
1. License exact name...
Dear All,
I am facing an issue with PSTN dialing. Sometimes users are complaining that they are not able to make PSTN calls from Cisco Phones. We check Router pattern, route list etc everything is fine. However, issue got resolved after re-starting o...
Dear All,
I am facing an issue with my IPT. I am receiving 0 on my Cisco IP phones if somebody is calling on our Analog DID. We have Cisco Voice gateway registered with our CUCM. We have FXO lines configured on our voice gateway. If am calling someon...
Dear All,
I am facing an issue with IPCC agents login. Mostly on every week, my agents does not work. On Cisco IP phones, I am seeing error " Selected IP phone Agent service is not active" on the phone". Please select another service.
while checking...
Dear Rahul,
Thanks for your feedback. I am having one more doubt.
1) Do I need any license or anything else or need to purchase certificate to use certificate based authentication.
2) To allow FTPS, I need to allow only port 990?.
Please suggest.
Hi,
I think you are correct. Customer have not created any VIEWS and simply put VIEW keyword in usernames commands. I think this was causing the issue.
Thanks for your help.
Hi,
I am not able to see any view configuration in running config shared by client. I am not sure whether they have created parser view or not.
Will it show in show run config ?.
I am able to see only VIEW keyword in Username command and exec command...
