Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a c1111 set up for serving as a vpn server i can connect to it with a desktop and anyconnectto set that up was quiet a hassle for me so i dont want to mess with its settingsi am not at the location and would need access to the local network on...
equipment c1111 ipbase4x lan ports (i think l2 ports ?? you cant create sub interfaces on them cant do no switch port and so on)2x wan ports can create subintarfaces on them and seems to have a larger comand set then the prvios 4c2960x ipbase (yes it...
i have a c1111 router and a c2960x with routing enabled an lte router is connected to the c1111 0.0.0.0 on the c2960x is to the c1111on the c1111 i do set the next-hop with a route map to the lte routers ipthat works finemy question isif i connect th...
how can i set the next-hop for a vlan? this is for local traffic from the router it self like ping trace sla ...the router has a default gateway over a build in cellular lte connectionso ping 8.8.8.8 will go like --> lte - 8.8.8.8 vlan 123 (10.0.0.2...
i have an isr with a build in LTE modem i can set up nat and it worksnow i want to connect a second lte with an external modem and some devices should use one or the other connectionif i put the external modem in passthrough mode it sets up a default...
this is the ip i want to redirect or some other from this subnetinterface GigabitEthernet0/0/1
ip address 10.21.0.1 255.255.255.0
no ip redirects
ip nat outside
negotiation autoand here it connects to the 2960interface GigabitEthernet1/0/4
no sw...
version 16.9
no service pad
service timestamps debug datetime msec localtime show-timezone year
service timestamps log datetime msec localtime show-timezone year
service password-encryption
service internal
service sequence-numbers
platform qfp utili...
no service pad
service timestamps debug datetime msec localtime show-timezone year
service timestamps log datetime msec localtime show-timezone year
service password-encryption
service internal
service sequence-numbers
!
hostname c2961
!
boot-start-m...
routing between 10.10.0.0 and 20.0.0.0 is done by the c2960xso accessing 10.10.0.10 or 10.10.0.20 from 20.0.0.25 will godesktop --> c2960 --> homeassistantwhat i try to acomplis is10.20.30.1 should bring me to 10.10.0.10 OR 10.10.0.20depending on if ...
@MHM Cisco World thanks a brief test seems to show it will workthat currently it didn't (a trace dies at the lte) is probably because the lte isnt set up correctly in the moment havent got time for it till nowthis next-hop is some what confusing to m...
