Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm afraid I need some hand holding as I am a bit overwhelmed at the moment.I have four AIR-CAP3502I-E-K9 with LAP without a controller. I would like to(1)Update the LAP to the latest version without using a controller(2)Install vWLC as controllerI a...
I purchased four AIR-CAP3502I-E-K9 access points for home/lab use.The access points have the following firmware installed respectively:12.4(23c)JA3, 12.4(23c)JA3, 12.4(25e)JA1, 12.4(23c)JAI would like to update them all to the newest firmware and pos...
I have been having problems with wifi with mainstream equipment in a home/apartment scenario (peak season - 3 apartments with several tens of devices using wifi) and am looking for something that works. For the switch, I have been considering new/use...
I am looking for a catalyst switch for a home lab/ 3 apartment scenariowhich would allow VLAN's and give me the possibility to learn more aboutnetworking. As an example, I found the following used switch on ebay(Cisco Catalyst 3750G WS-C3750G-24TS-S1...
I’d appreciate a recommendation for new networking equipment to cover 4 floors including the cellar. At the moment I have the following equipment:Location - cellar rack- ISP router acting as modem (location cellar rack)- Asus RT-N16 router (router +...
Much appreciated- I will then continue setting up the vWLC and connect this one ap to it. If it all works out, I caneasily repeat the procedure for the others.
I’m not sure whether everything is OK after all, could someone please comment ?I have attached:- console log file of ap with updated firmware- console log file of an ap whose firmware was not updatedFor the updated ap:under the line “******** AUTOMAT...
Sounds great. I just want to check the calibration issue as per that post above and need to give a commandin ap# prompt - how do I stop the logging output so that I can type the command ?Will get back once I complete all 4 ap's.
This is for home/lab use, I just bought the 4 access points without a controller and theyall have rcvk9w8 firmware (forgot to mention that since I didn't know what that impliedat the time).I couldn't follow the MODE related instructions or the Telnet...
Just to be sure I am doing everything right. I am dealing with a 3502i access point.Does the new firmware need to be of a particular name as is in the link you gave for therespective access points the link refers to ?Do I need to delete any file from...
