About vjekobalas

vjekobalas · 04-26-2020

I'm afraid I need some hand holding as I am a bit overwhelmed at the moment.I have four AIR-CAP3502I-E-K9 with LAP without a controller. I would like to(1)Update the LAP to the latest version without using a controller(2)Install vWLC as controllerI a...

vjekobalas · 03-19-2020

I purchased four AIR-CAP3502I-E-K9 access points for home/lab use.The access points have the following firmware installed respectively:12.4(23c)JA3, 12.4(23c)JA3, 12.4(25e)JA1, 12.4(23c)JAI would like to update them all to the newest firmware and pos...

vjekobalas · 11-07-2017

I have been having problems with wifi with mainstream equipment in a home/apartment scenario (peak season - 3 apartments with several tens of devices using wifi) and am looking for something that works. For the switch, I have been considering new/use...

vjekobalas · 11-05-2017

I am looking for a catalyst switch for a home lab/ 3 apartment scenariowhich would allow VLAN's and give me the possibility to learn more aboutnetworking. As an example, I found the following used switch on ebay(Cisco Catalyst 3750G WS-C3750G-24TS-S1...

vjekobalas · 01-20-2017

I’d appreciate a recommendation for new networking equipment to cover 4 floors including the cellar. At the moment I have the following equipment:Location - cellar rack- ISP router acting as modem (location cellar rack)- Asus RT-N16 router (router +...

vjekobalas · 05-04-2020

Much appreciated- I will then continue setting up the vWLC and connect this one ap to it. If it all works out, I caneasily repeat the procedure for the others.

vjekobalas · 05-02-2020

I’m not sure whether everything is OK after all, could someone please comment ?I have attached:- console log file of ap with updated firmware- console log file of an ap whose firmware was not updatedFor the updated ap:under the line “******** AUTOMAT...

vjekobalas · 04-30-2020

Sounds great. I just want to check the calibration issue as per that post above and need to give a commandin ap# prompt - how do I stop the logging output so that I can type the command ?Will get back once I complete all 4 ap's.

vjekobalas · 04-30-2020

This is for home/lab use, I just bought the 4 access points without a controller and theyall have rcvk9w8 firmware (forgot to mention that since I didn't know what that impliedat the time).I couldn't follow the MODE related instructions or the Telnet...

vjekobalas · 04-27-2020

Just to be sure I am doing everything right. I am dealing with a 3502i access point.Does the new firmware need to be of a particular name as is in the link you gave for therespective access points the link refers to ?Do I need to delete any file from...

Member Since	‎01-19-2017 08:28 AM
Date Last Visited	‎10-25-2020 11:44 AM
Posts	22

User Statistics

User Activity

AIR-CAP3502I-E-K9 updating LAP without a controller

AIR-CAP3502I-E-K9 access point questions

need recommendation for low power switch upto 24 ports

3750 Catalyst ownership costs

Recommendation needed for more professional home network equipment

Re: AIR-CAP3502I-E-K9 updating LAP without a controller

Re: AIR-CAP3502I-E-K9 updating LAP without a controller

Re: AIR-CAP3502I-E-K9 updating LAP without a controller

Re: AIR-CAP3502I-E-K9 updating LAP without a controller

Re: AIR-CAP3502I-E-K9 updating LAP without a controller