Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all
In the same network configuration as the image, the C9300#2 equipment intermittently displays mac flapping logs, and the C9300#1 and C9300#2 become Root Bridges respectively.
At this time, ICMP communication from C9300#2 to adjacent switches ...
Hi all,
I’m reaching out because this is my first time setting up an AP.
I need to configure two Catalyst 9115AXI APs.
One of them will serve as both the Controller and the AP, while the other will only function as an AP and join the Controller.
Coul...
Hi all.
I am using two WS-C3650-48PD-S switches, and Gi1/0/47 and Gi1/0/48 ports for each switch are connected by setting them as port channels. ( Boot System : cat3650_caa-universalk9.16.06.04a.SPA.bin )
When checking with the show interface command...
The reason why the stack was not configured is a configuration that the customer does not want, and other system configurations of the customer use it like that, so it is configured as it is now
Sorry, I think I took out the g22 port and sent what I tested.I'm sending it back to you.
#show spanVLAN0001Spanning tree enabled protocol rstpRoot ID Priority 16385Address 04bd.97af.d180This bridge is the rootHello Time 2 sec Max Age 20 sec Forward ...
The "show spanning tree summary" setting cannot be checked today, so I only send the "show spanning tree" setting, and it is in normal operation.The "C9300-2 error" file in the attachment is "show spanning tree" and log at the time of failure.
