Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, everybody. Faced with such a problem. (which probably occurred after the DC update) FMC1500Software Version 6.3.0.4 (build 44)OS Cisco Fire Linux OS 6.3.0 (build21) No user activity in Analysis -> User -> User Activity. I am using Cisco Firepowe...
Good day to all. After updating ISE 2.2 to 16 patchA message appeared.DescriptionNo User Authentication events were collected by the Identity Mapping service in the last 15 minutes.Suggested ActionsIf this is a time when User Authentications are expe...
Identity Services EngineGood day. I am trying to add a custom network device profile. The profile is created but settings are not saved inside it. (See attachment) Does anyone know how to solve the problem?My account is in the superadmin group. ISEVe...
Good day. Please tell me how to transfer the database to HA mode on standby FMC.log from standby FMC /var/log/syncd.log Config database is not in HA. at /usr/local/sf/lib/perl/5.10.1/SF/Synchronize/HADC.pm line 3765.Config database is not in HA. at /...
Hello,
We had upgraded CUCM from version 10.5 to 11.5. Our support contract is expired so we can't migrate licenses.
Can we install 10.5 version again via "Software Upgrade -> Install/Upgrade" procedure?
Hello, cybergeezer.Thank you so much for your answer.I hope DC means defense center?I attached the output files from the FMC and from one of the sensors.Thank you in advance.
Have same problem. Before 8841 was 7841.
We use QM as recording server.
I tried change the "Advertise G.722 and iSAC Codecs" -- not helped.
If you resolved this problem, please advice.
Best Regards,
Aleksey.