Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Mr. Ordoñez.Were you able to find out something new for this case? Do you need us to provide you with some more information?We await your kind response.Thank you very much.
Thank you very muchAny additional information you need, please let me know. If it can help you, I can also access the ap through another one that acts as a remote controller(attached you can see). But we still don't see a solution...By the way, do yo...
Good morning.
We have a problem with the device mentioned above.
We are deploying this AP as EWC on another subnet.
First we install the EWC image and then we only put the IP of the subnet that we want (it is in another physical location).
Once conne...
Thanks Rich!Sorry, the version we installed is 17.08.01.I don't know why it searches for the ip 192.168.1.1, isn't it a default search?We cannot provide you with the boot log because the AP is in another physical location and at the moment we do not ...
Hi Scott.Thank you for your reply.I answer:At the moment in the location where this equipment is located we do not have a cable to connect by console.In relation to isolating the AP, we already did it, we put it in an isolated vlan, but it was still ...
Hi Rich. Thanks for your reply.I attach several screenshots to answer your questions.In the image with the "show run" you will see that the configuration appears as if it were in capwap mode.However, in the image of the "show version" command I attac...
thanks for your reply.Before trying to link it with the WLC that I mentioned before, we tried that in its physical location it took its own ewc, but as I have shown you before, there is no way. If it is true that in this location there are other Cisc...
@Daniel Ordóñez Flores Thank you for your quick answer.
We have tried the first command you quote on several occasions and it indicates that the EWC image is already installed (attached screenshot). We have also tested the second command and it does...
