Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guysI am studying CCNP-ENCOR book.I have a doubt, which is the priority default value of interface partecipate to LACP?In book example, it set G1/0/2 with command "lacp port-priority 1" and G1/0/2 become activeIf i look for documentation, default ...
Hi,someone can help me?I have Cisco 1841 with WIC1T board, SerialI have Cisco 2921 with WIC2T board, Smart SerialSomeone know which is code of Cross Cable to connect together?And is it possible to connect second port of WIC2T to other router?Thank yo...
HiI am building an home laboratory with some routers.I'd like to know if can I connect Cisco 1841 with WIC-1T interface to a Cisco 2921 with HWIC-2T interface?The true cable should be CAB-SS-2660X?
Hito join and enable AIR CAP1702 to AIR AP2802 i need TFTP server on my laptop to upload firmware (c3700) to AIR CAP1702.Everything seem works.Is it possible that AIR AP2802 run as TFTP server?andIs it possible to upload c3700 firmware on it? Where i...
HiI don't understand what license need to configure ACL (Access List) to new switch Cisco.Can C9200L configure this full feature in ingress and egress? And which license type need?The question is quite strange but I have discovered that other manufac...
2nd link is my conversation, 4 mounth ago and I absolutely forget it. Genius!1st link I have just read it some days ago but i don't understand cisco P/N, but I think that it dosn't exist cisco cable with this pin-out. I think that is custom cable for...
Hithey talked about other type of cable.I need help to know if two serial port with different interface type can run with cross cable cross that have code: CAB-SS-2660X
Can not AIR AP2802 be a firmware's repository?In the logs of AIR AP1702, it tries to download firmware from Wireless Controller.What are cli commands to see wireless controller directory?
