Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we have a new requirement to use the 3602i in office extend mode at one of our customers sites. Previously they have been using the 600 series AP and they are working fine. Technically we know this should work, but we are facing some push-back ...
Hi, I am wondering about best practices when trying to mark and classify webex video traffic from the users PC client. I have looked around and nbar is possibly one option or i could match on the destination and ports of the traffic.But i'm wonderin...
I have a 3560 switch newly installed and have created a mgmt VLAN (999) but the line prot is down and won't come upVlan 1 is shut down and 2 other vlan's exist Vlan 2 (user data) and vlan 700 (voice) which work fineUsers are plugged in and working, v...
HelpI'm trying to redistribute some statics into OSPF using a route map (see config). However they don't enter the routing table. I've searched the web but can't find what i'm missing any ideas? config attachedcheers
Hi when using aaa authentication on my 3560 switches the banners remove all the blank space i put in and left align everything. without aaa auth it works ok. any ideas
Thanks, I knew something wasn't right in their statement but struggled to find information to back me up. I will discuss this with them tomorrow
thanks again
Thanks for the reply, just so I'm clear we have two WLCs in the solution, a primary 8510 WLC within the main network and a 5508 WLC in a dmz servicing the remote office extend ap's
we would connect the 3602 ap to the 8510 WLC on the main network fi...
thanks for your reply, yep we are trying to give them a guarantee them bandwidth across the WAN to the internet edge, what happens to it after that is obviously best effort. We have been given the webex server IP's so will match on that + https. T...
I have an installation where the switch access port faces a phone (7942 or 7962) with a subtended PC.The PC is also running a Cisco softphone (IP Communicator).The switch config has the option of programming the port to trust either a phone OR a soft...
