About khalilsoltani47714

khalilsoltani47714 · 01-19-2022

I currently have 2 x 9300L switches, which are operating in stack I have the management port in its management vrf with the interface set to ip address staticI have upgraded the IOS to 17.3.3IS show me error 034526: Jan 19 14:43:35.438: %HMANRP-6-E...

khalilsoltani47714 · 01-18-2022

In the SD-Access "DNA Center" when used embedded wireless controller in the Catalyst 9300/9500I would like to know compared to the traditional networkthe EWC(9800 software running on a Catalyst 9300/9400/9500) is working in local switching or Central...

khalilsoltani47714 · 01-10-2022

I have two switch C9300-48T on stack, now i need add other Switch memeber 3My question is when i add switch member 3 is need a restart for the two switch en production

khalilsoltani47714 · 12-07-2021

Group-Based Access Control navigate to Analytics is not show me anythingI create SGT and i do same policy, integrate with ISE and Stealwatch host groups is success butin the Policy ---> Group-Based Access Control ---> Analytics not visualize my netwo...

khalilsoltani47714 · 12-02-2021

I migrated the printers to new SD-Access networkPrinter type kyocera connected to Fabric domain ""No authentication""in my desktoop printer is pingable but cannot open in the browserin traditional networks I manage to access but now no

khalilsoltani47714 · 01-19-2022

@balaji.bandi always same error034558: Jan 19 15:10:50.577: %HMANRP-6-EMP_NO_ELECTION_INFO: Could not elect active EMP switch, setting emp active switch to 0: EMP_RELAY: Could not elect switch with mgmt port UP034559: Jan 19 15:10:50.583: %HMANRP-6-...

khalilsoltani47714 · 01-18-2022

@Benjamin-A if i understand correctly in the Fabric SD-Access when enabled EWC in switch C9300 and AP is support only on mode Local not support Flexconnect ..!

khalilsoltani47714 · 01-10-2022

thank you @Reza Sharifi I read this article, if I understood correctly the other switches in stack should not need to restart

khalilsoltani47714 · 12-02-2021

yes i have ise , but now my desktop and printer in the same VN and no authentication -not used ISE now for this action my desktip in the sgt X and printer in the SGT Y is pingable and cannot open in the browser,

khalilsoltani47714 · 11-22-2021

Yes fabric domaine enable, in the same fabric domaine. Same buildingEmbedded wireless in the edges node c9300 floor 1And embedded wireless in the edges node floor 2 c9300, the second embedded wireless not installed show me error provisionsAnd need so...

Member Since	‎12-01-2020 02:39 AM
Date Last Visited	‎02-11-2022 12:01 AM
Posts	35
Total Helpful Votes Received	10

User Statistics

User Activity

9300 Management port Could not elect active EMP switch

SD-Access EWC(9800 software) work local or Central Switching

Switch Catalyst C9300-48T On stack

Cisco DNA Center feature Analytics not visualize the SGT, ISE

Migrate Printer to SD-Access and cannot open in the browser

Re: 9300 Management port Could not elect active EMP switch

Re: SD-Access EWC(9800 software) work local or Central Switching

Re: Switch Catalyst C9300-48T On stack

Re: Migrate Printer to SD-Access and cannot open in the browser

Re: Error Install package wifi (Embedded Wireless wifi) in the fabric