Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have to monitor a Cisco 3825 I'm using in order to interface PRI PBXs; 3825 is SIP controlled.SW version: Cisco IOS Software, 3800 Software (C3825-IPVOICE_IVS-M), Version 12.4(21), RELEASE SOFTWARE (fc1)I would like to know which are the MIBs i hav...
Hello,I want to limit the bandwidth on the 2811 FE interface.I'd like to bring it from 100 to 34 Mbps up and 34 MBPs down.Could you please give me the sequence of command to apply in this case?Thanks a lot,simone
In order to know how much bandwidth is used on a particular interface (copper or optical) i'd like to know if i can use snmp traps (something like snmp-server enable traps interface fastethernet X/Y but i didn't found it) and if yes wich command to u...
Coul you please help me understanding how can i measure the IP traffic ( percentage of bandwidth used istantaneusly/avarage/....)on an interface? For example a Fast Ethernet interface on a 6509 with IOS. Thanks, Simone
Hello,could you please tell me wich is the command in order to avoid the possibility that users that have only the RO (read only) snmp password priviledge, to read the community psw RW.Is it snmp-server view....? Do yo have same example?tks a lot,Sim...
I'm going to provide you the show ver about 6500 in few days, now i'm not near the devices.Another thing i have to solve is the same scenario but with 3560 IOS EMI (3560 A is running 3560 B is just turned on). This last is more urgent than 6500. Is i...