Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am having a CISCO 2811 with 8 voices FXO Interface. Currently only 4 lines are terminated to the FXO Interface (LINE A, LINE B, LINE C, LINE D). Out of the 4 lines 2 lines are dedicated to the bosses (Line A and Line B). Therefore only 2 lines a...
Hi, Happy new year to all of you!!!Hi,I have a small issue!While deploying a Cisco Catalyst 3560, 24 10/100/1000 port switch in the LAN I am facing some routing problems. The switch is configured with 3 VLANs, and DHCP for the respective VLANs.VLAN A...
Hi,I have two number of Cisco catalyst 2950T switches, 24 ports with 2 gigabit ports.Earlier both the gigabit uplinking ports were connected to a Cisco 4507 switch by means of four UTP cables for redundancy.Recently one of the physical cables was cut...
Hi,I have a C2610 router.I issued "erase startup-config" and reloaded the router and after this i am not able to make the router boot. it is going to ROMmon prompt.I also checked the article in : ROMmon Recovery for the Cisco 2600 SeriesRouter and th...
HI,I am installing PIX 515e through the PDM.Looks like I have entered all the required information correctly but still not able to access the internet.The router is working fine and I am able to access the internet if I connect my pc, with a range of...
Dear Jon,Thanks. I have done exactly what you have said. I have put the modem in the same VLAN as of the users. But still for the users, the switch is dynamically assigning IP addresses with 10.185.34.1 as the default gateway whereas the modem IP add...
Dear Steve,Thanks for your responce. I tried tto enter the routers manually before but my 3G internet modem is not allowing to enter any static routes. I am using a sony erricson 3G internet modem. It has only a web interface . Doesnot allow telent a...
Hi Satish,Thanks for your reply. In fact one of my guys wanted to get some hands on with the router and may be he has issued the erase flash CLI instead, by mistake.Now this router is very old and I don't have any smartnet subscription with cisco. I...
Hi,Thanks Buddy. It solved my problem. Global and Nating was missing.I tried to do same kind of nating through the PDM but it didnot accept...no clues why? Never thought of entering through the CLI.ANyways. Really appriciate.Thanks...to all fo you gu...
while I try to access the switch it is getting restarted. and we are getting some error msges.UNHANDLED ROMMON EXCEPTION at PC=0b000c14Vector=00000100 MSR=02021200 LR=0b000790MCSR=00000000CISR0=00000000 CISR1=20000000DDR_ERR_DETECT=00000008 any clues...
