Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm monkeying around with an 881-W. Clients can associate and authenticate to ssid 'test', but they cannot get a DHCP address. Clients plugged into f 0 - 3 get DHCP addresses just fine. I've looked at a lot of different guides, ran debugs etc. Wh...
I'd like to hear your thoughts on whether AAA services for device administration (routers, switches, etc) should be mixed with AAA services for user services (like 802.1x) on the same server(s), or whether you think it's best to separate the two func...
Have all IOS commands been assigned either priv 1 or 15 by default since time immemorial? Or at some point in the past were some commands assigned priv level 0 by default?Thanks muchThanks
I've never understood why it is recommended to run BPDU guard and root guard on access ports. It seems a bit redundant to me. If you're running BPDU guard, and a superior, inferior or otherwise BPDU is received on a port, BPDU guard err-disables th...
I'm looking to hear your thoughts regarding the VSS based on your hands on experiences. Is it good or bad and why? Have you run into any odd edge cases that have made you wish you stuck with the non vss 720s? Thanks,
Nice, that did the trick. You know what was a killer on this one? All of the documentation I found specifically directed to configure the gig0 interface as I had. At any rate, thank you very much.It's obviously time for me to bone up on IRB.
You answered it. I found a passage in a Cisco Press book that stated that all commands are either priv level 1 or 15 by default, which conflicted with my understanding. So perhaps the book doesn't consider disable, enable exit, help and logout as "...
Greetings,As I said to another individual that posted, I'm not looking for information on what the VSS is/does. I'm looking to hear input on people's real life experiences with the VSS.
I appreciate your input, but I'm looking to hear what people's experiences with the VSS are. I have already done my homework and an aware of what it is/does.
