Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,i have a question regarding Cisco Aironet design and config : well i have an existed Csico Aironet 350 based Wireless Link ( point-to-point) connection between Site A( Head Office considered as Root Bridge) and Site B ( Remote branch co...
Hi ,i have one cisco Aironet 350 using Channel one connected to an outdoor OMNI antenna( 12 dbi) Mounted on a tower of 20 meter height and providing connectivity to multiple remote sites , i am planning to add another Cisco Aironet 350 in the same...
Hi,i received the following Bill of Quantity to start a Cisco IP telephony instalaltion :1- MID-MKT-IPC-K9-C: 3-Server, CCM 100 User Red., Unity VM 25 User Bundle, 3DES2- LIC-CM-4.X-900U= :CallMgr 900 Usr License for MID-MKT-IPC-K9-B and C3-UNITY-VM...
Hi,i have a cisco router 3640 running the following software :c3640-is-mz.122-1a.bin and having RAM of 64 MB.-the first slot is equipped with one ethernet and two serial interfaces module-the second slot is equipped with four serial interfaces mod...
Dear all,i am trying to setup an H323 VoIP between a Multitech voice gateway MVP400( in the Head Office) with Cisco ATA186 ( in a remote branche connected to HO through WAN) .as a first scenario , i have configured the MVP400 for FXS operation ,...
Hi,thanks for your reply,but the issue is : i am using Cisco WorkGroup Bridges 350 at the remote branches( Site C , Site D,..) and two Cisco Aironet 350 Bridges at the site B wchich used as a relay site.the problem i am facing is as i have all sit...
Hi,thanks a lot for your reply ,i have not recieve the software yet , i am in preparation phase ,regarding item #1 , is that mean that cisco unity voice mail is bundled with Cisco Call Manager , so no need for separate Cisco Unity Server ? in other ...
Hi ,Thanks again for your reply ,lel me ask you a clarification related to the fact that VoIP multitech is not forwarding any digits out the port, and as per your knowldge and experience , could it be caused by a mismatching of DTMF Regional...
Hi,Thanks a lot for your reply ,there is a feature on the Multitech called "call progress" for each channel , so when i checked this feature for the designated channel to troubleshoot the probelm ,i am seeing the call coming from the IP address of t...
