Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am testing out DNA Center's rogue on wire capabilities. I am able to detect a test rogue AP that connected to a lab switch. The lab switch is in DNAC. It shows as a Potential Threat and Interferer. However, it doesn't classify as on wire even t...
I've been unable to get netflow working on a Cisco 3750x with a C3KX-SM-10G module. I went over the configurations with Cisco TAC and we verified they are correct. However, Cisco states that I have to use the tenGigabitEthernet interfaces. Problem...
How does your channel utilization look? You can find that on the new homepage under network summary > access points. Or via the CLI one at a time.
There may be a need to adjust the number of APs with 2.4 enabled or adjust the power output on tho...
Check out this post:
https://community.cisco.com/t5/wireless-and-mobility/create-rf-profile-to-disable-2-4-ghz-radios/td-p/3086682
You can create an RF-Profile with all 802.11b data rates disabled and apply it that AP Group.
What is your DHCP solution? ie..Infoblox, BT Diamond, etc? This is where you have to enter the option 43 under those subnets which contain access points.
https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/97066-dhcp-op...
You have to console into the access point and deploy that command with the IP address of the WLC. If you haven't configured a global un/pw for those APs the default is Cisco/Cisco.
