Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All I am trying to figure how to run reports on a daily \ weekly basis that will show AP uptime per location \ AP total per location and I am really struggling to find a guide that shows how to do this. I have been able to figure out how to cre...
We have recently been advised to install 1562i access points for a new external wireless service. These were purchased and now installed in one location. One more location to follow. They are showing on the WLC (AIR-CT5520-K9) as downloading and have...
Since we migrated our entire infrastructure in our Warehouse environment we have had performance \ connectivity issues
Migrated from local 5508 WLC to offsite 5520
Migrated from 1242 APs to 2802e APs with Omni directional antennas (AIR-ANT2544V4M-R...
Okay so I have now figured out how to create and run the reports to see what I need however I now need to figure out how to email me the reports I added my email address but I get the message to setup SMTP server I know we are already have this setup...
Cisco TAC advised the following 8.5.140.0 supports 1562I Access point. If your controller is running that version, you can just add country domain and connect your AP. Below I have provided doc which has compatability information of software version ...
Clem58 what manual power settings did you use (auto is currently between 3 and 7 on our APs) and how high up are your access points.
After disabling clean air on 2 APs in the first isle I have had an immediate response of major improvement. I may h...
