Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a C9800-40 controller that does not send all configured telemetry data to our Telegraf/InfluxDB. Some subscriptions are sent, some not. This worked flawlessly for a few days, then some subscriptions stopped working without any change on our...
Hi,we have a bunch of C9800-40 controllers running IOS-XE 17.6.3. Yesterday, we discovered that from about 1.200 APs more than 50% were in monitor mode on the XOR radio. 2.4GHz coverage was very bad in some areas.On the FRA page in the GUI (Configura...
Hi,when we used FlexConnect, all the APs logged every single association and disassociation of a client, i.e.:%DOT11-6-ASSOC: Interface Dot11Radio0, Station aeda.0a63.xxxx REAP Associated KEY_MGMT[Open]%DOT11-6-DISASSOC: Interface Dot11Radio0, Deauth...
Hi all, can anyone give me a hint on how to get transceiver data (e.g. RX/TX power) out of Nexus 9300 series switches with NX-OS telemetry streaming? I have a working telemetry configuration, just need to know the "location" of the transceiver data f...
Hello all,I am searching for a way to get the location of all devices from DNA-Center via API.The only solution I found is to first get a list of device IDs (/intent/api/v1/network-device) and then get the details for every device (/intent/api/v1/dev...
I managed to solve the issue and it wasn't at all a problem with the C9800 controllers!The problem was in out InfluxDB itself. From Telegraf, I got lots of the following errors:E! [outputs.influxdb] E! [outputs.influxdb] Failed to write metric (will ...
...and here is the solution: SNMP traps that will be sent to syslog with the help of a trap handler script.First, install a SNMP trap receiver (Net-SNMP) with the following configuration (snmptrapd.conf) on your syslog server:disableAuthorization yes...
We managed to solve our problems. As soon as we removed all AireOS controllers from the RF-Group (split the RF-Group into two groups), FRA began to work on the IOS-Controllers again. The GUI does not show that (Last run and Last run time are always 0...
Hi,CSCvy37351 seems to fit my issue. I will upgrade from 17.6.3 to 17.6.4 during the night an we will see what happens afterwards.Thank you for the hint!Robin
