Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,One of my clients is having some issues at the moment.For context: The client is a multinational with branch locations nationwide. We have one controller resident at the head office, all the access points at the different locations are regi...
Hello All, I have a 2504 WLC at the office, and about 2 AIR-LAP1142N-E-K9. We moved to a new office space and since then, the access points have not been able to join the controller. I have attached the debug output. Kindly assist!!!
Hello All,We just moved from our old office to a new one. Since moving, my IP phones have not been able to register.Upon further troubleshooting, I discovered that the Call Manager (Cisco MCS 7800 series) is not reachable via ping despite being power...
Hello All, I configured AAA on a c9300-48P, but I can't seem to login to the switch using the AAA credentials. Find the configuration below:SW#sh run aaa! aaa authentication login AAA group tacacs+ localaaa authorization exec AAA group tacacs+ locala...
Hello Everyone, My client has a 3945 router serving as a voice gateway. They was a power outage last week and suddenly my client can't make outbound calls. Everything seems to be okay, they was no configuration change but they still can't make outbo...
Hello Bandi / All, the DHCP server for the SSID is situated in the head office. Do I have to enable anything on the WLC or do I have to replicate the network address on the local DHCP server too ?
Hello Andrew, you're right. The AP's are running Flexconnect mode like you rightly stated. The users majorly having this issues are mainly at branch locations. The issue is in 2 forms:1. When users connect to the reported SSID on some access points, ...
Hello Bandi, the WLC is 3500 series controller. The DHCP server is located the head office. Other SSID's are able to issue out IP addresses. This is not a new SSID, It has been existing for a while. It just happened that users cannot get ip addresses...
Hello Roger, thanks for your response.I've been able to resolve the issue. The MCS was connected to a wrong port on the switch. We changed the port on the switch where it was connected and the issue was resolved.
Hello Andrew,Many thanks for your response. I read through the field notice you attached and it was helpful.I issued the commands below on the controller: ap cert-expiry-ignore ssc enableap cert-expiry-ignore mic enableIn addition to the commands abo...
