Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I need to connect a HQ office to 3 branch offices over point-to-point T1's.I know I can use frame relay for this but what other way will work? Is it possible to have 3 routers talking to 1 router with 3 WIC-1DSU-T1 cards, each with its own P2P T...
Hi, I am connecting 2 offices with 1841-T1SEC/K9 routers over an AT&T point-to-point T1. I have always done this with Internet T1's and IPSec VPNs in the past. What is the best practice for data encryption in this type of connection, is it even nee...
Hi, I want my 2851 to stop allowing login attempts after 3 failed attempts and to (if possible) send an email to the network administrator about the failed login attempts. Can anyone help with this?Thanks in advance! Mitchell
Hello All,I need my router (2851) to mark VoIP packets on the egress I/F (Gi0/0) before sending them to my core switch (4006) with a COS value of 5. I created a policy map to do this but when I try to apply the policy map to the egress I/F I get thi...
Hello, I have a 2851 at HQ and 2821 at 2nd site. Using IPSec VPN to connect the two LANs and it is working fine. Now I want to connect another LAN at each site across the same VPN. I want to keep traffic separate between the LANs. Is this possible...
Hi Collin,Thanks for your post, I was not aware of EEM and will spend some time looking through it. I think it will work for the email notification.About the login retries, my router already resets the interface after 3 failed login attempts, but th...
Hi Glen,Thanks for your input, I am aware that the CatOS does not support "auto-qos trust" etc., thats why I need to set the COS value on the packets at the router egress I/F before they reach the switch. You can see from my original post what went ...
Hi Brad,Thanks for your input, but the CatOS does not support these features, thats why I need to set the COS value of the packet at the router egress I/F before the packets arrive at the switch.Any ideas?Thanks,Mitchell
