Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Apparently now you need a contract to download CSR1000v images. Even though licensing is enforced on the platform itself and what I can recall it is unrestricted for 60days (trial) and will be locked to 100kbps throughput. If that is the case then wh...
I've been trying to terminate multiple VLANs in AWS instance of CSR1000v. The scenario is like this:
VLAN 400 [CPE] --(L2)-- CSR1000v [Remote PoP] --- (L3 Link) -- CSR1000v [AWS] (SVI 400)
I've tried VXLAN between remote end CSR1000v and AWS CSR100...
Dear Fellows,I'm trying to establish VXLAN tunnels between Arista Switch running EOS (4.14.4F) and Cisco ASR9001 running IOS-XR 5.3.0. The problem I'm facing is that Arista Only supports unicast flooding of vlan to particular VTEPs while Cisco ASR900...
its tricky though.. I've 3x1G in production working for quite sometime without any issue but the traffic going through is imix not specific to any destination nor from any specific source. It all depends on the platform and which hashing algorithm is...
What I'm assuming here that the switch you have used do support limited L3 support, just like 2960 but doesn't support "ip routing" and therefore, can't do routing and because the DG on PC is the SVI therefore, its not going anywhere. Make router the...
Its unclear what do you mean by "at its best". Questions to answer..
Draw a network diagram
What are the cisco router models?
Are they all in a single broadcast domain?
How much traffic you are sharing between wired and wireless devices?
are you usin...
There is no reason for router to convert a FIN to a RST... I've seen similar behavior in past, once with a SAP implementation but just a corner case (or maybe no one ever discovered it after that).
Please refer to this post.
https://supportforums.cis...
Can you mirror the port from Palo Alto FW and check what packets are arriving and what FW is returning back. Try both Egress and Ingress ports to give clear picture.
