Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I have a VG310 with a two port T-1 card installed. I have configured the Gateway as a MGCP in the Call Manager and using qsig. The Primary call manager shos registered and the other call managers show as backup ready in the VG310. I have...
Hi All, We are moving over to Cisco CUCM and installing various models of analog gateways to support faxes, bells and paging. I have setup a VG204 with FXS for a Valcom Paging System. We have a Valcom 9940 that sits between the VG and the 9 zone pa...
Hi All, I'm new to Cisco UC CUCM platform. I'm trying to setup alarming via SNMP. I have setup 1/2c SNMP/Traps and V3 with no luck in using the "utils snmp test" command via CLI. I have followed all the config steps in both 1/2c and v3 with no luc...
Hi Enes,Thank you for your response. I'm looking to delete some of my Import and Export jobs in CER. If you go to CER, Subnets and click on Import on the right-hand side, you should get a pop-up window that says import IP Subnets. On that window wher...
Hello, I'm curious if you were able to get the Algo to work on the "ring" and "In-use" events. I'm trying to install the Algo 8138. I can only get it to ring and light the strobe. But no luck in the "ring" and "in-use" mode. Our CUCM is on 14.1.
Hi Steve, Thank you for your response. This was an existing V-9940 which was working with AudioCodes. I think the issue is with the new analog gateway configuration. I may have fixed the issue, but I wont know until I'm in the office tomorow..Than...
