I have a wan site that has one router connected back to 2 routers in my main campus over 2 different links for redundancy. i want to use l2tpv3 to bring a dot1q network back from that remote site to campus i have that working however i want to ensure...

on a 2950 and above maybe some lower.. if you go in config and enter this on a interfaceswitchport access vlan 300however my switch was not configured for vlan 300 it creates a vlan 300 container on the fly. i want to know is there a way to turn that...

I had no other devices associated besides my laptop.I did a 100+ meg download and noticed I was getting about 750-850KB per sec = approx 6mbs. In my a/b/g client card I unchecked the 2.4 - 11M seeting. So I was hoping to see the stated 22 Mbs through...