Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
An old CISCO AIRONET 1240AG SERIES 802.11A/B/G ACCESS POINT datasheet details using the 2.4 GHz radio as the AP and the 5GHZ radio for backhaul. Repeater mode isnt used.Is this a supported configuration as I cant find any configuration guides for it....
I Notice in the Networkers presentation RST-2502 WAN and Branch QoS Design that when LLQ and FRTS are implemented that the priority queue bypasses the shaping process.Has anyone seen a reference for thisIs this also true for class based shapingthanks
Is it possible to view the contents of the AIM CUE flash such as with dir or show flash.I am trying to determine what makes up the wear shown in show interfaces ide 0
what I am concerned with is that I cant find a single example of this on CCO and this scenerio is removed from the latest version of the Datasheet (which was the only place that referenced it). Maybe it is a push to use mesh instead of bridging
Using MCQ to implement FRTS needs to be done on the class-default, you can then shape within the MCQmap-class frame-relay test service-policy output Shape-and-Queuepolicy-map Shape-and-Queue class class-default shape average 2000000 service-policy ...
If the device is looking for an address off the local network it will need to go to the default gateway, this is typically the router (L3 device).The L2 switch doesn't understand any of this, it just learns which interface to use to reach a particula...
