About rkoloj

rkoloj · 01-26-2022

I have a Firepower 2110 connected to a 3850 switch with an access port. I have FMC on a VM on the switch that my Firepower is connected to. Overnight, I don't turn off the switch its connected to and it will seemingly boot to ROMMON mode. I have n...

rkoloj · 11-08-2021

Hi I have a Nexus 9K connected to a Cisco UCS. I am having trouble logging into the Cisco UCS via the console port. I have been trying to find docs about how to login via the console port. Is there a console port? Do I have to "jump" to the UCS f...

rkoloj · 08-17-2021

2 Cisco ASA 5520 - 1 primary, 1 backup, using a laptop to console in 1st problem:the 'http server enable' command is on the running-config of this ASA. also, the command 'ssh 192.168.1.0 255.255.255.0 management' exists in the running-config. I the...

rkoloj · 07-09-2021

This is something that I always wanted to understand with more granularity. For example, you want to configure OSPF on a router.Say you configure the routing statement below on the G0/0 interface: R1(config)# router ospf 1R1(config-router)#network 1...

rkoloj · 07-07-2021

I can't ping between 2 Nexus 9k's. Both interfaces are configured as follows: Nexus Switch 1:int eth1/18 ip address 192.168.1.1/31 no shut Nexus Switch 2:int eth1/18 ip address 192.168.1.2/31 no sh I also tried configuring an 'ip route' on either sw...

rkoloj · 11-08-2021

Cisco UCS 6248UP, thanks for helping.

rkoloj · 08-17-2021

Yes this command is in the running configuration

rkoloj · 07-07-2021

ugh duh, ok i'll try that. thanks.

rkoloj · 07-07-2021

I cannot post full configuration, its a secure network. Version: nxos 9.3.7 However, here is the features: feature bgpfeature isisfeature nv overlayfeature vn-segmentThe interfaces are: Nexus Switch 1:int eth1/18 ip address 192.168.1.1/31 no shut N...

Member Since	‎07-01-2021 08:40 AM
Date Last Visited	‎02-11-2022 12:01 AM
Posts	10

User Statistics

User Activity

Firepower 2110 boots to ROMMON and couple other questions

Trouble logging into Cisco UCS via console port

Can't GUI into Cisco ASA 5520 & persistent log -- can't login

What exactly happens when you type in a routing statement?

Can't ping P2P between 2 Nexus 9k's

Re: Trouble logging into Cisco UCS via console port

Re: Can't GUI into Cisco ASA 5520 & persistent log -- can't login

Re: Can't ping P2P between 2 Nexus 9k's

Re: Can't ping P2P between 2 Nexus 9k's