Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,We've changed our Hotel Wifi APs to Cisco 9120-AX with Catalyst 9800 controller. We're running into an issue where through the hallway the signal is good, but several rooms on each floor have weak or inconsistent signal strength. The APs are...
Good day,Two things;1. Why can't I run the port utilization report for less than 50%?2. I'd like a report of ports that are down/administratively shut down for security reports, to show that ports that are unused are disabled. I would think DNAC woul...
We are currently moving from older Brocade switches to new Cisco 9300s software version 17.03.03. Mostly the change has gone well, except for a really strange issue. We have hard-wired PCs and tablets that use an application that prints shift receipt...
We have some C9105AXW-B for this scenario. I'm trying to set one up and the WiFi is normal, broadcasting public, but I'm working on trying to route the VoIP through the LAN1 port for in-room phone and not sure how this works.
Over a year later I'm able to respond. After a few issues we overcame with the help of TAC we are now on version 2.3.5.6. We now have access to the report and after running it, under the Admin Status column it shows either UP or DOWN. I was hoping th...
Yes, the only thing changing is that we are moving the connection of the AP (Ruckus R610) from the Brocade switch to the Cisco Cat9300. We are running the application on two tablets which are connected to Wi-Fi, and three other Windows 10 PCs runnin...
Thank you for the response and polite guidance on what you would like to see. No IP has changed. The Printer is static and wired and the user devices (2 tablets and 2 wired PCs and 1 wireless PC) do not change between AP connection swaps. The only th...