Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Networkers, I have a question regarding the output of show inventory and the snmp entity-mib.
Normally when I need an inventory of a IOS box I use the entity-mib or the show inventory information. The entity mib gives a lot of output of field r...
Hello, I have got a question regarding configuring HSRP only on one switch stack. The L1 configuration is as follows: _____ _____ | SW1 |-| SW2 | |_____|-|_____| | | __|__ __|__ | |-| | | SW3 | | SW4 | ...
My problem: When a router with a cellulair interface or only the cellular card is replaced in the field this means restoring the saved configuration is not enough to get the box running again, first a few exec commands should be given.With kron comma...
Is it possible to use the EasyVPN feature to auto-update EasyVPN IOS clients and if yes, what name should be used as the client name and rev?crypto isakmp client configuration group testgrp auto-update client NAME? tftp://1.2.3.4/c870-advipservicesk9...
Hello, I want to supply this issue with some extra information and experience:
"aaa authentication login default tacacs line" instead of "aaa authentication login default tacacs enable" does fall-back to the line password so that one works. So "tacac...
You can also use the command "clear ip arp" which clears the arp table without sending the gracious arp messages. You will see this has more effect as it takes longer to re-learn the arp entries.
I'm also looking for this info. I was trying to find it under the entityMIBObjects, which should be the correct place to store this info but it is not there. Also the CISCO-IETF-VDSL-LINE-MIB is not supported on these kind of devices. So I guess ther...
Ok, some ideas:
You can change the location of the startup config from nvram to flash with the "boot config flash0:startup-config" command. After that command do a "copy running-config flash0:startup-config" command to save the current configMaybe th...
This link describes the rev parameter, but does not say if it is possible or not possible to upgrade IOS based EasyVPN clients. Does anyone know for sure this is not supported?
