Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to configure the feature access code for FXS port in the same CME. I try to follow "Configuring FXS Ports for Basic Calls" http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxsbasic.html, I met a problem. In order to ...
As stated in Selling Cisco Unified Communications Express "http://www.cisco.com/en/US/partner/products/sw/voicesw/ps4625/prod_brochure0900aecd804790c1.html", Cisco Unified CallManager Express supports Boss Secretary features and Cisco Unified CallMa...
The administration guide states clearly that FAC features work with all Cisco IP Phone models and MGCP-controlled analog gateway. I would wonder that FAC features work with digital gateway on PRI connection or not?
For Router IOS, I understand that it does not have problem creating translation rules for VoIP that matched and replaced a defined pattern on called number or calling number. Is there a possible way moving portion of called number (says first four d...
I understand that it does not have any problem to display the enterprise data from IVR (IPCC) on Desktop Agent. Does it support data/message display on Phone Agent?
Basically, I understand that FAC/CMC is defining in Route Pattern. And it should be working if matching the pattern. However, the section "Interactions and Restrictions" of Client Matter Codes and Forced Authorization Codes and even in the IP Telep...
You could go ahead with /30. However, you must be carefully planning the ip address ranges, routing protocol that are being used and the routes that you need to propulate.
A few suggestions at this moment, as shown in your configuration, you may use access-list 150 later on. However, you do not require access-list 1 so you can remove access-group on the interface. And after you turn off ip cef, it has disabled all ro...
