About elliot_adlerson

elliot_adlerson · 02-19-2025

Hello folks,I want to migrate my edge firewall from the Cisco to the fortigate and i want to apply the following:-Allowing the users and denying them in global ACP base on user in user section in ACP.-Applying Malware and intrusion (NGFW features) po...

elliot_adlerson · 02-19-2025

Hello folks, I want to migrate my edge firewall from the Cisco to the fortigate and i want to apply the following: -Allowing the users and denying them in global ACP base on user in user section in ACP.-Applying Malware and intrusion (NGFW features) ...

elliot_adlerson · 09-30-2024

Dears,I was wondering if its possible to create a local realm on the fmc and then add local users to that realm and also force DUO MFA for these local vpn users ?Or Cisco DUO only support LDAP Users ?Thanks.

elliot_adlerson · 10-05-2023

Guys, as you can see in the attached picture I noticed that some ssids operate in 802.11ac while the other ssids are only broadcast in 802.11n even though they are using the same access point.So where can I change that?

elliot_adlerson · 01-16-2023

Dears,I have Cisco IPphone 7911-7975-7937 models and i want to use them with other call mangers and PBXs like Grandstream is it possible to register the above models with other solution rather than Cisco if I used SIP firmware ?i know that the above ...

elliot_adlerson · 06-11-2025

Hello @rezaalikhani ,Did you able to get CoA to get working in your environment with Unifi APs ?Also can you please let me know whats does Radius:Acct-Session-Id = 0 mean and is there any documentation reference to this ? or can you please share the ...

elliot_adlerson · 06-03-2025

Hello@thedarkstalker Did you got the chance to fix the issue ?iam having same issue.Thanks.

elliot_adlerson · 02-20-2025

@Rob Ingram belive it or not the issue was on ACP you should not use SSL/VPN range in source network and user at the same time. i tested with ACP which only defined user and leaved source network empty them worked!So that was the issue at that time ...

elliot_adlerson · 02-20-2025

Dear @raymng .Did you allow user in ACP in user section ?Regards,

elliot_adlerson · 02-20-2025

Dear @HMHMHM Thanks for the answer.I just want to allow the user base on the ACP as your first approach, the question is can i only allow or deny specific user in the ACP base on realm? or is this approach is correct?Regards,

Member Since	‎01-11-2022 01:22 PM
Date Last Visited	‎06-14-2025 12:43 AM
Posts	35
Total Helpful Votes Received	6

User Statistics

User Activity

FTD SSL/VPN and NGFW

Appling NGFW features For the ssl/vpn user traffic

Authenticate the local FMC VPN Realm users with DUO

enable 802.11ac on SSID

Registering Cisco phones with 3rd party call manger

Re: Integrating Ubiquiti APs with ISE - RADIUS CoA Configuration

Re: CoA : Cisco ISE and Ubiquiti/UniFi Access Points

Re: FTD SSL/VPN and NGFW

Re: Access control policy in the Remote Access VPN Firepower

Re: Appling NGFW features For the ssl/vpn user traffic