Hello All,
We run the BGP over the IP Sec Tunnel, so we need to create the PAT to translate the incoming IPs from FW 1 to the loopback interface to communicate with the other subnet in the firewall 2 via the loopback interface.
so i need to know h...
Hi all ,
This error is appeared on switch 2960 i need to know what this error ?
%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/5: Power given, but Power Controller does not report Power Good
Hello all,
I set the dot1x and the Raduis configuration on 9300 switch to authenticat the end user and Run the Daynamic vlan for the users but the user can't connect with the raduis server ( Pulse ).
Version : 17.09.03
My Configuration :
int...
hi
this issue on VPN initiated between cisco asa and cisco rv 320 router the vpn tunnel is estableshed but this IKEV1 error appear in debud
Apr 12 21:05:43 [IKEv1]Group = DefaultL2LGroup, IP = 177.8.169.134, Session is being torn down. Reason: crypt...
I already applied this configuration, but still the NAT is not working, so to fix this issue, I set the IP NAT inside & IP NAT outside under the IP sec tunnel by the CLI template because I didn't find the IP NAT inside & outside under the Cisco VPN I...
Dear ,
Kindly be informed that this issue is related to some ports not all ports and the phone is directly connected to the switch
Admin-4 uptime is 15 weeks, 5 days, 18 hours, 24 minutes
System returned to ROM by power-on
System restarted at 2...
Admin-4#show cable-diagnostics tdr int gigabitEthernet 1/0/1
TDR test last run on: August 31 15:57:14
Interface Speed Local pair Pair length Remote pair Pair status
--------- ----- ---------- ------------------ ----------- ------------------...