About visitdemo11

visitdemo11 · 06-06-2019

Hello Guys,I need help with the configuration of adding additional E1 channel to a Cisco router ISR4331. This is Urgent

visitdemo11 · 06-09-2017

Hello, I am having an issues listening to recording from the Cisco Workforce Optimization portal. I am seeing internal server error and unable to load energy data. Kindly Advice. What I have done so far I have restarted the server and also I have...

visitdemo11 · 11-23-2016

Good Morning, I was at a customer site yesterday and we want to upgrade the ESXi hyper-visor from 6.0 - 6.5. I was able to access the kvm console and I associated or mapped the ESXi 6.5 iso file to the Blade server. I restarted the server so that it ...

visitdemo11 · 11-10-2016

Good Morning, I want to ask if Smartnet covers cable. I deployed Cisco UCS infrastructure for a customer and one of the twinax cable got bad. The customer is asking if smartnet covers cable replacement.

visitdemo11 · 02-09-2016

Hi Everyone My team is currently deploying a Cisco UCS for a client here in Nigeria, we have two chassis, two FI, two MDS san switches, one switch for management and one switch (Nexus 9372px) for Uplink. We have a challenge currently, after we associ...

visitdemo11 · 06-06-2019

Yes, I have the NIM card and PVDM-4 card.The configuration is what i need.I will be glad if you can share a sample config

visitdemo11 · 11-01-2017

How did you solve this issue?

visitdemo11 · 02-16-2016

Hi Walter, we boot to SAN Yes..The ESXi has been configured with IP add, mask and gateway we didn't specify vlan for ESXi config We have a native vlan

visitdemo11 · 02-16-2016

Hi Walter, The Link between FI and N9K is up. kindly find attached report I pulled out from sh mac address-table vlan 101. I'm still having the same problem. sh mac address-table vlan 101 is showing limited mac addresses sh mac address-table vlan 102...

visitdemo11 · 02-09-2016

Hi Walter, I have vlan 101 for management, vlan 102 for vMotion, and vlan 103 for VM. The FI is in Ethernet End Host Mode. Can you explain more on the ports being configured as a network ports? Thanks

Member Since	‎01-10-2015 02:47 AM
Date Last Visited	‎06-17-2019 09:14 AM
Posts	12

User Statistics

User Activity

Adding a Second E1 channel to a Cisco router ISR4331

Cisco Unified Workforce Optimization

KVM issue. Help!!!

SMARTNET

Can't See The ESXi MAC addresses on the N9k switch

Re: Adding a Second E1 channel to a Cisco router ISR4331

Re: CUPS 11.5 not allowing XMPP clients to authenticate

Hi Walter,

Hi Walter,

Hi Walter,