About Kenneth Goh

Kenneth Goh · 09-18-2024

I am trying to configure EMM but the option to configure track is missing? Please help, thanks in advanced.

Kenneth Goh · 03-26-2024

CSR router R9 and R10 are suppose to form site to site IPsec VPN using digital certificate where R12 is the CA Server. R10#ping 40.0.1.1 so lo0Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 40.0.1.1, timeout is 2 seconds:Packet ...

Kenneth Goh · 12-16-2023

I am running GNS3, as shown in the diagram, how do I allow R1 in vrf RED to be able to ping to R2 int vrf BLUE? Why are the no option to create route-target? NXOS1(config)# vrf context REDNXOS1(config-vrf)# address-family ipv4 unicastNXOS1(config...

Kenneth Goh · 10-19-2023

I had intermittent ping drop issues which initiate ping from the switch itself when ping to it's own SVI ip address Switch#show ip int briefInterface IP-Address OK? Method Status ProtocolVlan10 192.168.24.14 YES NVRAM up up p...

Kenneth Goh · 10-14-2023

Hi, I am currently using vEdge version 20.3.1. I managed to onboard vEdge to vManage and did not create CSR on vEdge. As shown in the steos below I successfully onboarded vEdge to vManage. I would like to confirm if there is a need to generate CSR on...

Kenneth Goh · 09-18-2024

I need to use Event Manager Applet, not IPSLA, also as shown in post there is no option for event pattern. Please help provide screenshots so as to avoid misunderstandings.

Kenneth Goh · 09-18-2024

Hi @Giuseppe Larosa, the IOS XE version 17.9.5 rel fc1 is already shown in my post. This is a C9300-24T switch.

Kenneth Goh · 12-25-2023

Apologies, I managed to add the static routes under vrf context. Thanks for your help!

Kenneth Goh · 12-25-2023

Hi @Harold Ritter There is no option to enter 'vrf' NXOS1(config)# ip route 10.10.2.101/32 ethernet 1/2 ?. Sub interface separator/ Slash separatorA.B.C.D IP next-hop address in format i.i.i.i NXOS1# show run !Command: show running-config!Running co...

Kenneth Goh · 12-17-2023

Managed to create vrf below, can route leaking be done via only static routes? vrf context BLUEaddress-family ipv4 unicastroute-target import 1:1route-target export 2:2vrf context REDaddress-family ipv4 unicastroute-target import 2:2route-target expo...

Member Since	‎06-14-2010 02:57 AM
Date Last Visited	‎09-23-2024 01:57 AM
Posts	85
Total Helpful Votes Received	83

User Statistics

User Activity

EEM event track command missing

MM_NO_STATE 0 ACTIVE (deleted) in IPsec Site-to-Site VPN

VRF route leaking on Nexus 9k

How to verify CoPP Class-map

Is there a need to generate a CSR on the vEdge router?

Re: EEM event track command missing

Re: EEM event track command missing

Re: VRF route leaking on Nexus 9k

Re: VRF route leaking on Nexus 9k

Re: VRF route leaking on Nexus 9k